Skip to content

Andrés Blog

Blog about electronics, embedded system design and computer programming

Tag: bootloader

Howto: Remanent data after microcontroller software reset

I recently needed to write a special bootloader for the STM32 controller. One requirement was the ability to explicitly start the bootloader from the application. In this case the bootloader stays active until the next power cycle or when a firmware upgrade has been successfully applied.

Published 2015-02-16
Categorized as Software development Tagged bootloader, stm32

Pages

  • About
  • Datenschutzerklärung

Categories

  • Electronics (11)
  • Projects (6)
    • Project: Active Load (6)
  • Software development (7)
    • STM32 (3)
    • Tools (1)

Archives

  • April 2017
  • March 2017
  • September 2016
  • May 2016
  • April 2016
  • March 2016
  • February 2016
  • January 2016
  • February 2015

Tags

active load bootloader fsmc hack kicad low power pcb pinswapping project python ram rfm69 rfm69hw solder sram stm32 usb

Recent Posts

  • Keep an eye on prices of web shop products (python-pricewatch)
  • A clean CMake-based STM32F4 template for kickstarting new firmware projects
  • USB: Virtual COM ports under different (Windows) operating systems and the driver problem
  • Getting a custom board outline from an .svg file into KiCad
  • Quick hack: Add native (user) USB to ST’s Nucleo boards

Meta

  • Log in
  • Entries feed
  • Comments feed
  • WordPress.org
Andrés Blog
Proudly powered by WordPress.